Makermotor 3/8" Shaft 12v PMDC Gear Motor Variable Speed Drive 12vdc Gearmotor

Description

This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with a PWM (Pulse Width Modulating) controller.  The gear motor is measured to be 7 inch long and the motor itself has a diameter of 2.5 inches.  Drive shaft is a
3/8" shaft with 1 flat ("D" shaft) where flat to OD is 0.322" and the length of the shaft is 0.886" long.
Rated voltage of this gear motor is 13.5 VDC and maximum speed is 50 RPM.  Rated output load is 60 watts and output
toruqe at 50 RPM is 6 N-m (4.4 ft-lb).  Mounting is based on M6 screw mounting.  The 12V DC PWM controller features a 5
inches(12.7 cm) long connection to its potentiometer.  The potentiometer has a on/off switch built-in with a knob.  An overload
protection is set at 6 amps of current so the controller will shut down when such a current occurs.  There are connectors
between the gear motor and the controller.  To run the gear motor in CW rotation, please connect motor's green connector to
controller's red connector and motor's red connector to controller's black connector.  To run the gear motor in CCW rotation,
please connect motor's green connector to controller's black connector and motor's red connector to controller's red
connector.  The distance of the connection wires between the motor and the controller is 10 inches(25.4 cm).  The distance of
the 12v connection wire is 46 in(116.8 cm) long.