-40%
Leeson D.C. Gear Motor M1115024.00
$ 184.8
- Description
- Size Guide
Description
APPLICATIONS: This gearmotor is designed for mounting at any angle, but motor below the reducer should be avoided to prevent leakage of lubricant into the motor should the motor shaft seal fail. Motor’s stall torque could exceed recommended full load torques. A current limiting device such as an SCR control should be used to prevent damage. This issue is even more critical for low voltage motors, typically no controller is used since motor is connected directly to a battery, so some type of current limit or fusing should be considered. Overhung load capacities shown are at center of output shaft.FEATURES:
Made in the USA
Steel frame
Precision machined in-line steel gears
First stage steel helical gear followed by spur-type gears
Lubrication is permanent semi-fluid grease, reducing possibility of leakage
Output shafts have needle bearings for high load capacities
Shafts are hardened steel
General Specifications
Model : 985.602D
Catalog No : M1115024.00
Output HP : 0.05
HPOutput KW : 0.04 kW
Voltage : 90 V
Current : 0.56 A
Speed : 5
RPMService Factor : 1
Efficiency : 41.6 %
Duty : Continuous Insulation
Class : F
Frame : 30
Enclosure : Totally Enclosed Non Ventilated
Overload Protector : No
Ambient Temperature : 40 °C
Drive End Bearing Size : 2034
Opp Drive End Bearing Size : 2034
UL : Recognized
CSA : Y
CE : Y
Technical Specifications
Rotation : Reversible
Mounting : Special
Shaft Type : Parallel
Overall Length : 9.91 in
Frame Length : 3.36 in
Shaft Diameter : 0.625 in
Shaft Extension : 1.5 in
Weight : 9.00 LB